Radiator Exhaust Lower Block-Off Plate (RT Models 2010-19)

Lower vent makes driver foot hot on the RT. Upper tends to make passenger foot hot. Harvey said you could use both plates together, but must remove the bottom pan... But no one talks about adapting the inside deflector. I removed the bottom side pan and 2 lower bolts for the inside deflector. Then cut the bottom half of the deflector off, rerouting the wires and securing the wires and deflector with wire. The plates themselves are good. Now to test in hot weather...

I installed the lower block-off plate yesterday and went for a long ride wearing sandals just to see if I would get a hot foot. No more hot foot! thanks for a great product. I also did not notice any engine overheating.
It was easy to install once you get the screw started!

I ordered and put this piece on my bike. I haven't tested it on a ride yet, but I'm positive that it's going to work. The instruction was really easy to understand and follow. I installed it in 10 minutes.

Easy to install. It really works.

prompt delivery and the jelly beans were great. thanx

Thanks for the fine product and all your help.

So far so good.

Again , another great product for the spyder !! Still, a little too cold to feel the difference, but living in the northeast doesn't help lol... Easily installed, but when installing with the stainless grille, you need a longer bolt.. A quarter inch or so... Otherwise, GREAT !!!!

Works great for removing the heat from right foot.